A Hunts can weighs 0.65 lb and is 2.58 in. in diameter. A Great Value can weighs 0.54 lb and is 2.50 in. in diameter. What is the largest bearing stress that occurs between the cans and the table? Assume each can has a smooth base and sits flat on the table.

If the normal stress in rod (1) is limited to 230 MPa and the required factor of safety is 2.1, determine the maximum load P that can be applied to rod (2). Let a = 0.43 m, b = 0.82 m, and the cross-sectional area of rod (1) be 195 mm2.

A steel rod with a 1.75-in. gage length and a 0.190-in. diameter is loaded in tension. At the proportional limit, a load of 1,100 lb elongates the gage length by 0.00207 in. and reduces the diameter by 0.000065 in. Determine the Poisson’s ratio.

A load of P = 200 lb is applied to beam ABC. Bar (1) has a circular cross section with a diameter of 0.85 in. Determine the normal stress in bar (1). Let a = 35 in., b = 13 in., and c = 8 in.

A Ro-Tel can weighs 0.71 lb and is 2.52 in. in diameter. A Libby’s can weighs 1.08 lb and is 2.90 in. in diameter. What is the largest bearing stress that occurs between the cans and the table? Assume each can has a smooth base and sits flat on the table.

A load of P = 155 lb is applied to beam ABC. Bar (1) has a circular cross section with a diameter of 0.88 in. Determine the normal stress in bar (1). Let a = 35 in., b = 14 in., and c = 11 in.

Rigid beam ABC supports two rods that initially have no strain. If a temperature increase in rod (1) creates a normal strain of 3,045 μin./in. in it, determine the normal strain in rod (2). The initial lengths are a = 8 in., b = 15 in., c = 34 in., and d = 9 in. Assume there is no slack in the connections.

If the length of a timber [E = 1,000 ksi] column cannot change by more than 0.045 in., determine the maximum load P that can be applied to the column. Let b = 4.25 in., d = 9.25 in., and L = 110 in.

A 3D printer is used to create a shock absorbed composed of two polymers. Polymer (1) [E = 160 ksi] has a cross-sectional area of 1.2 in.2. Polymer (2) [E = 240 ksi] has a cross-sectional area of 1.2 in.2. After the shock absorber is loaded between steel plates by load P = 480 lb, determine the load carried by polymer (1).

If the length of a timber [E = 1,500 ksi] column cannot change by more than 0.045 in., determine the maximum load P that can be applied to the column. Let b = 6.00 in., d = 9.25 in., and L = 102 in.