It is recommended that kVp not be used to control beam quantity because:

Determine the heat units for the following.  Do not round off your answers. Include only two digits pass the decimal. 300 mA, .5 sec., 95 kVp, 3-phase, 12 pulse 

Using the anode cooling curve below, answer the following questions. If the anode reached its maximum heating capacity, how many minutes will it take to cool back down to 50,000 heat units?   

What interaction is shown below? Then label A and B. (3 points)

If 100 kVp and 300 mA is used, what is the maximum exposure time?

To increase the quantity of radiation by adjusting the kVp to the same level as doubling the mAs, increase kVp by a factor of:

The device that adjusts the incoming power supplied to the x-ray circuit to maintain 220 V is the:

Anode melting is the result of:

Label clearly. Looking at the photo, what is the…….. Total Resistance? Total Current? Volts across Resistor 1: Volts across Resistor 2: Volts across Resistor 3: Volts across Resistor 4: Is this a series or parallel circuit?  

Place the following events leading to the production of x-rays in order, from first to last: I. kilovoltage is rectified II. voltage is adjusted at the autotransformer III. anode and cathode develop large positive and negative charges  IV. voltage changes to kilovoltage