Where is the default Tool Center Point located on a Robot?

After inspecting the robot work cell to make sure that it is safe to operate, what is the first item that would normally be turned on when starting up the robot?

In which directions would you jog this robot to make its tool move to the point shown if in World mode?

How is a robot’s Continuous Test function different than the Single Step Test function?

What keeps program file data from being lost when a robot controller is turned off if the controller uses Static Random Access Memory?

Which type of robot gripper can adjust its finger position based on feedback from an encoder?

When a robot is in automatic cycle, what function is active on the teach pendant?

What term is used to describe the collection of points a robot can reach when it moves through its total range of motion?

Which jog frame mode would be easiest to use to jog the robot tool tip along the line shown on the work piece surface with the tool 1 mm away from the surface?

What type of robot has a work envelope that is shaped like a box?