Which of the following stirrup designs is not acceptable?

Assuming Vs exceeds 4sqrt(f’c)bwd, the maximum spacing for vertical stirrups in the following beam is _____. Let b = 16 in. and d = 35 in. There are four No. 7 longitudinal tension bars and No. 5 stirrups at 12 in. o.c.

The determination of whether a reinforced concrete floor system is classified as a one-way or two-way system is based on the ratio of the span lengths for the floor slab in the two principal horizontal directions.

The Mueller-Breslau principle is not helpful for structures that will be analyzed via computer software packages.

A beam has dimensions of b = 14 in., h = 28 in., d’ = 2.5 in., and d = 25.5 in. It is reinforced with 2 No. 5 bars on the compression side and 4 No. 8 bars on the tension side. The concrete strength is 3,100 psi, and the yield strength of the reinforcement is 60,000 psi. If the depth of the neutral axis is c = 5.205 in., determine the strain in the compression reinforcement, ε’s.

Which of the following best describes a smeared-crack model?

A simply-supported beam has a 1 kip/ft uniformly-distributed load over the entire 8-ft span. What is the magnitude of the maximum shear force in the beam?

In designing for shear, one must ensure that the flexural strength equals or exceeds the shear strength at all points in the beam.

As the size of coarse aggregate increases, the roughness of the crack increases. This allows higher shear stresses to be transferred across the crack.

The use of compression reinforcement permits the use of more tension reinforcement to decrease the strength of a given beam section while keeping the section compression-controlled.