If there are concentric circles, then it is recommended that… If there are concentric circles, then it is recommended that you apply the center mark to the ____________circle. Read Details
Which of these options is available in the Ellipse drop-down… Which of these options is available in the Ellipse drop-down menu? Read Details
What type of geometry can be used to create lofts: (A) sketc… What type of geometry can be used to create lofts: (A) sketches, (B) surfaces, (C) model faces, or (D) points. Read Details
In the drawing shown, which of the two circles has the cente… In the drawing shown, which of the two circles has the center mark been applied to? Read Details
What is the minimum number of guide curves required to creat… What is the minimum number of guide curves required to create a Loft? Read Details
What view feature should be used for a drawing view that is… What view feature should be used for a drawing view that is too large to fit on the sheet, like the one shown below? Read Details
A basic Sweep feature requires a ____________. A basic Sweep feature requires a ____________. Read Details
What is the minimum number of sketches needed to create the… What is the minimum number of sketches needed to create the loft shown in the image? Read Details
Which sketch tool was used to create the curve shown in the… Which sketch tool was used to create the curve shown in the image? Read Details
